Garboli tube washing and drying machines clean the external surface of straight round metal tubes in one guided passage. Spray washing removes oil, grease, dirt and surface residues using a suitable water-based detergent or cleaning solution. An air-blade stage then removes residual washing liquid. Cleaning requirements and tube dimensions determine the applicable setup.
All Washing Drying machines
WASH
Washing and liquid management
The tube moves through a spray chamber with self-centring guidance at the inlet and outlet. Filtration and recirculation manage the washing liquid. The choice of cleaning agent and operating settings must suit the material, contamination and cleanliness required before the following operation.
PLC-controlled feed is adjustable from 1 to 10 m/min in the available configuration. This interval is a machine capability, not a fixed cleaning rate for every tube or contaminant. The required result must be established for the actual workpiece and process.
Drying and the following production stage
After washing, the air blade removes liquid from the outside of the tube. The combined sequence can operate independently or connect with other equipment. A clean external surface may be required before further processing, but suitability for the next operation depends on its cleanliness and dryness specification.
Washing removes contaminants; it does not replace abrasive grinding or polishing. Garboli metal finishing machines and drilling machines cover separate operations that may be included in the manufacturing route. Contact Garboli with the tube dimensions, material, contamination and required condition after drying to discuss the washing cycle.
Frequently asked questions
It washes and dries the external surface of compatible straight round tubes.
The cycle addresses oil, grease, dirt and surface residues using a cleaning solution suited to the material and contamination.
Yes. The configuration can operate independently or integrate into a production route, with feed and transfer specified for the actual tubes.
No. It is the adjustable feed capability of the available configuration. The selected rate must produce the cleanliness and dryness required by the process.
